First you need to remove the bad gear clutch, the method is as follows: (1) Use a screwdriver to unscrew the screw fastening seat control, seat control or removed, and you should be careful not to deadlift connected with water pressure in the pipe behind the washing machine ; (2) use a screwdriver to unscrew Sheng bucket fastening screws on the fixed circle, remove Sheng buckets fixed ring; (3) with a screwdriver to unscrew the impeller screw, the dissolution of the pulsator, pulsator out under the square plug gaskets, then you can see the following holder barrel washing and dehydration dehydration above the axle nut, then use special tools or wrenches to dehydration axle nut, and then come up with the clutch gear shaft dewatering pad sets, split out, wash bucket dehydration, dehydration sets in and then out of the shaft gasket; (4) the washing machine forward dumping, it facedown, you can see the structure of the lower washer spin with a socket wrench or a small under tight fixation on the screws, remove the bracket, then remove the V-belt, and then unscrew the socket wrench or a small pallet on the fastening screw fastening deceleration clutch, so that you can remove the clutch gear a.
     Change the order of the clutch gear clutch gear in reverse order of removal. That first clutch of new gear for the fastening screws on the pallet, and then fitted with triangular belt, holder, put up the washing machine, the clutch gear shaft dewatering installed gasket, and then loaded washing dehydration barrel, cushion sets, axle nut fastening dehydration, installed side-core gasket, impeller, and impeller with impeller screw fastening, and finally installed Sheng bucket seat can be fixed ring and control.